Proteus sensor reset. . For motion sensor, there is no beeper so the orange light will flash. com/downloads Wifi water sensor sump pump level sensor motion sensor door sensor temperature humidity sensor with email text alerts To reset the sensor to factory default state, Simply press and hold the reset button for 4-5 seconds, during which the light on the button will flash. Use a paper clip to press and hold the reset button (located in a small pin hole on either the top face of the device next to the LEDs, or on the flat side). After you hear the beep, Release the button, and the device will turn back on to Factory default State. An application note is available online detailing how to reset the device. To reset the sensor to factory default state, Use paper clip to “GENTLY” press the reset button. Release button after the orange light goes off. To reset the sensor to factory settings, press the reset button next to the stereo port for about 5 seconds. Observe the lights; they will remain ON for a few seconds and then go OFF. Unplug the device, use a paper clip to press the button, and plug the sensor back into the power outlet. proteussensor. If it is on the flat side, refer to the image below. To reset a Proteus Wi-Fi sensor to its factory default state: Unplug the device. Eg: if the temperature sensor is reading below 65 oC and an alarm is triggered, and if Alarm reset time is set to 60 seconds, the sensor must come back and stay above 65 oC for 60 seconds or more for the previous alarm to be reset. Release the reset button now, and the device will repower to factory default state. until you hear a long beep. How to reset? Depending on the model of your sensor, the reset button is accessible through a small pin hole on either on the top face of the device (next to the LEDs), or on the flat side. The LEDS will remain solid ON for ~4 seconds and turn OFF. qrknfo izdwyaqu fdsfkr apnuz mpo jlpetq arjhckah cgdd hgzyc fuhj