Mack mp8 engine bolt torque specs. .

Mack mp8 engine bolt torque specs. If you feel information contained on this website may be incorrect, please contact us. SB 237-020, Unit Injector Yoke Hold-Down Bolt Torque Specification (September 2017) MACK CHU, CXU, GR, GU, and PI trucks built from 2009 to 2017 and equipped with MP7, MP8, and MP10 engines (EM-USA10, EM-USA14, and EM-USA17) will require a new torque specification for the Unit Injector Yoke Hold-Down Bolt. Heavy Duty Pros does not assume responsibility for the accuracy of this data. Should have also mentioned to make sure all the oil collected in the bolt holes is removed and to make sure the rocker shaft is pulled down tight against the cam blocks before torqing the bolts. Mack MP8 manuals, engine specs and bolt torques at Barrington Diesel Club. . This front sump engine oil pan is made of steel, finished in black and fits Mack MP8 / D13 engines. Note that illustrations and instructions are based on information that is subject to change as new engine/chassis development continues. Hope this helps RM. Jan 18, 2014 · MP8 rocker bolts the 12 small bolts are 18 FT pounds +120 degrees, the big bolt is 44 ft pounds + 120 degrees. The information, specifications, and illustrations in this publication are based on information that was current at the time of publication. The adjustable idler gear bolts are M12s, and they are torqued to 26 plus 120°, which almost seems like it will be the same torque as the camshaft bolts when considering the degree turn. Effective . pjvncm ndbmle mldsliz elr zpcza gfphuk wiopue vrkst pyx gcodxri