Dt466e cranks but wont start. What I do know is that it does not show any codes.
- Dt466e cranks but wont start. This is the first E-series motor I have so don't really have a clue where to start. Dec 28, 2015 · Probably at this time if you can either pull start the truck or either fire it you will find that you get at least 2-3000psi at throttle snap, if so the HPOP and regulator are probably fine. Hooked up reader and I am getting about 340psi injection control pressure while cranking. What I do know is that it does not show any codes. Checked for fuel leaks and did not find any. The job went smoothly until I went to fire up the engine. The ECM needs to be powered up as it allows the starter to crank. Apr 14, 2008 · An old truck driver friend of mine said to keep pumping until it got hard to press down and keep doing that after each time I try to start, it finally primed and I have a primer pump on order. Hasn’t started since. In this video we show 2002 DT466E engine starting issues we had and how we fixed them. I have located a fuel leak but it's just in the return line back to the tank. What could have happened?. I checked all electrical at the battery and cleaned the connections. If the ecm is not booting up the starter will not crank. Aug 23, 2011 · Fuel seems to build pressure at the bleed valve. Jul 8, 2019 · Recently I replaced the fan clutch on my engine. Dec 1, 2011 · Have a 2000 International 4900 with a DT466E that will crank but won't start. Oct 19, 2019 · Double check your ecm powers and grounds including those fuses at the battery box. I cranked it and it started like normal, I walked out of the bus and turned to look at the fan and the engine shutdown. lmeuq cwvbh ywlj oswy ftqqz ysso dqf xwlhl vvclba vtevgw