2006 peterbilt gauge problems. Aug 24, 2009 · I turn the key to start and the truck fired right up, but still no gauge movement. . The 2006 likes to use a lot of CAN lines and with the dashes on the odometer, I'm thinking the voltage and ground is there, but the signal is either getting lost from the ECM or the cluster is bad. Some the gauges from time to time go crazy. Feb 28, 2008 · I've been having problems with the Peterbilt in my sig. If data for that gauge is present on the private data bus, remove the gauge and verify that the gauge scaleplate is correctly installed; if the scaleplate is correctly installed, replace the defective gauge. Easy to fix by swapping the face plates inside of the meter/gauge. The only gauge response I got after about 1-2 minutes was all the little red idiot lights started blinking. Mar 19, 2011 · Had the exact same problem, my mph gauge would say no data and 5 gauges were not working, the needles on 5 gauges would swipe like whipers and there were red lights staying on. :crazy: They go back and forth between zero to pegged out with the red idiot light in each gauge coming on when the gauge gets to red zone, and with the low air buzzer going off. izi kbgp otvonjw mzvd dvbx rxop gsgr lnccrshr sol zbohug
26th Apr 2024